Table of Contents
Advertisement
1) DVB-T: modulating standard; XX.XXX MHz: the current output frequency; 576i:
video resolution of signal source; X.XX Mbps: the current encoding bit rate
2) Alarm Status: For example, if the CVBS cable disconnected, it will display Video 1
Not Lock under this menu.
3) Uptime: It displays the working time duration of the device. It times upon power
on.
4) Video Parameters: User can enter the items respectively to view the video status
and signal source resolution. User can also adjust values of rest items (Bit rate:
1.000~19.000 Mbps; Brightness & Contrast & Saturation: 0-255; Hue: -128 -
+127) and select Aspect ratio between 16:9 and 4:3.
5) Audio Bit rate: Select audio bit rate among 64, 96, 128, 192, 256, 320, 384 kbps.
Broadcast: Enable – the output program will broadcast only audio without the
picture; Disable – cancel broadcast mode to resume both audio and video.
6) Program Information: User can enable or disable the program output under menu
Program Output. User can also enter the other items to edit the Service Name,
Program Name, Program Number, and PIDs of PMT, PCR, Video and Audio, and
edit LCN (Logical channel number). EIT Event – User can enter this menu to
setup EIT (Event Information Table) for the current and next program event. The
EIT contains Start Time, Duration, Event Name, and Start Year of the event. All
the EIT information can be displayed on the TV screen on condition that the EIT is
chosen to insert (see explanation 10.).
7) TSID: (Transport Stream ID) User can view or adjust after enter this menu.
8) ONID: (Original Network ID)-User can view or adjust after enter this menu.
9) NIT: (Network Information Table) NIT table is a very important table for describing
the network and TS. User can enter the submenus displayed and edit the values
or select the LCN (Logical channel number) mode, and choose whether to insert
the NIT. If user chooses to insert the NIT, information (Network ID, Network
Name, LCD Mode, Private Data and LCN number of the program mentioned in
explanation 6) will be added to the transport stream.
NOTE: when the Private Data is set as 0*0, it is invalid.
Home Use
11
Advertisement
Table of Contents
