Philips 40PFL4707/F7 Service Manual page 27

[TYPE B]
Equipment Required
1. USB storage device
2. Remote Control Unit
Firmware Update Procedure
1. Turn the power off and unplug the AC Cord.
2. Insert the USB storage device to the USB port as
shown below.
Rear Cabinet
3. Plug the AC Cord and turn the power on.
4. After few seconds, the menu mode will appear in
the screen.
Note:
After 30 seconds without an operation, the menu
mode will disappear automatically.
To display the menu mode again, press the
[MENU] button on the remote control unit.
5. Select "Setup" and press the [OK] button to display
the setup menu.
6. Select "Software".
7. Select "Software update".
8. Select "USB".
9. Press the [OK] button on the remote control unit to
enter the update mode.
Update file selection screen appears as follows.
(Files included in the USB storage device are
displayed.)
USB port
Note:
To cancel the update mode, select "Cancel" and
press the [OK] button.
10. Select the file and press [OK] button.
USB storage
device
11. The update will start and the following will appear
in the screen.
Note:
If the above screen isn't displayed, repeat from
step 1.
12. Select "Yes" and press the [OK] button to update.
Note:
Do not remove the USB storage device or turn the
TV off while update is in progress.
13. When the firmware update is completed, the
following will appear in the screen.
Remove the USB storage device from the USB
port.
Turn the power off and turn the power on again.
7-3
" * " differs depending on the models.
*****_******.upg
Select an upgrade file
*****_******.upg
*****_******.upg
Cancel
" * " differs depending on the models.
Current Version: ***-****-***-*
New Version: ***-****-***-*
Are you sure you want to update?
No
Update your TV with new software:
Software update is successful.
Please remove the USB storage device
and restart the TV set.
1 2 3
Yes
Done
PL12.3FW