Enclosure Diagram - GE NX-320E Installation Manual

E
NCLOSURE DIAGRAM
Inside the can, several 2-holed insertion points have been constructed. This allows for either
vertical or horizontal placement of the modules. Notice that the insertion points have two sizes
of holes - a larger hole and a smaller hole.
Diagram 1: The black plastic PCB guides are grooved on one edge where the PC board will be
seated. The end with the half-moon protrusion fits into the larger hole. The smaller hole is for
the screw.
Diagram 2: Place the first black plastic PCB guide in the top insertion point, grooved edge
downward. The half-moon protrusion will be in the large hole. It does not require force. Insert
one of the provided screws into the smaller hole (from inside the can) to secure it in place. A
screwdriver should reach through the notch that runs the length of the guide to tighten the
srew. The second PCB guide should be positioned opposite of the first (grooved edge up) and
placed in the lower insertion point, using the same procedures described above. Once
mounted, screw it in securely.
Diagram 3: The PC board should slide freely in the grooves of both guides.
NX-320E Installation manual Page 22 19/09/05