GE TAX6 Use And Care Manual page 12

MOVE THE MAGNETIC FREEZER DOOR LATCH.
a. Remove the four small screws from the
magnetic door latch on the inside of the
freezer wall.
Place the door latch on the opposite side of the
b.
freezer where there are four predrilled holes.
c. Line up the holes in the latch frame with
the holes in the freezer wall, making sure
the magnetic side of the latch is facing you.
d. Insert the four screws to secure the latch.
THE FREEZER DOORAHD SPACER
a. Remove the six plastic plugs from the new
side of the fi-eezer.
the spacer with the six holes in the
b. Align
freezer's side wall.
c. Align the freezer door hinge with the spacer.
d. Insert the six plastic plugs in the six holes
opposite the hinge side of the freezer door.
NOTE: The magnetic latch should secure
the fi-eezer door when it is closed.
12
—
REINSTALL THE REFRIGERATOR DOOR
HINGES.
a.
Install the lower hinge.
Remove the three screws on the new side
1.
of the cabinet at the bottom.
2. Using the hinge with the hinge pin and
nylon washer, install the lower hinge.
b. Install the upper hinge.
1. Remove the three screws on the
REINSTALL THE REFRIGERATOR DOOR
a. With the door tilted slightly toward you to
clear the upper hinge, slip the hinge hole
on the bottom of the refrigerator door
over the bottom hinge pin.
Straighten the door so that the upper corner
b.
slides under the upper hinge and the upper
hinge hole aligns with the hinge pin hole.
c. Insert the upper hinge pin with
the Allen wrench.
CHECK THE OPERATION OF THE DOORS
a. Open and close the freezer door to verify that
the magnetic latch is positioned properly.
b. Open and close the refrigerator door to make
sure that the door gasket seals properly.