GE TAX6 Use And Care Manual page 11

IMPORTANT: The
door on your new
refrigerator can be installed to open from
the left or born the right. The swing of the
outer door and the freezer door both must
be reversed.
TOOLS REQUIRED
Medium-tip Phillips
screwdriver
Small-tip Phillips
screwdriver
REMOVE THE REFRIGERATOR DOOR
While holding the door steady against the unit
a.
to prevent the door from falling, remove the
top hinge pin with the Allen wrench and
gently pull the pin free with the pliers.
Pull the top of the door toward you far enough
b.
to clear the top hinge.
c. Pull the door upward with a slight jerking
motion to release it horn the bottom
hinge pin.
Remove the white nylon washer from the
d.
lower hinge pin, if in place.
I
Pliers
REMOVE THE REFRIGERATOR DOOR HINGES.
a. Remove the upper hinge.
Remove the three screws holding the
1.
upper hinge to the cabinet.
screws in the same holes.
b. Remove the lower hinge.
1. Remove the three screws holding the
lower hinge.
2. Set aside the hinge; reinsert
screws in the same holes.
NOTE: When reinstalling the door hinges, the
bottom hinge will become the top hinge and the
top hinge will become the bottom hinge.
3. Remove the hinge pin from the LOWER
hinge. Insert it in the UPPER hinge
removed earlier. Insert the pin so that it
points upward when the hinge is later
installed at the bottom of the cabinet.
4. Place the white nylon washer on
this hinge pin, if used previously.
5. Set aside both hinges.
Remove the six mounting screws holding the
a.
freezer door and spacer to the inside wall of
the tieezer.
Set the freezer door, spacer and six
b.
screws aside.
the three
11