Charging Battery For The Flx Crawling Copter - Odyssey TURBO RUNNER Manual

CHARGING THE BATTERY FOR THE FLX CRAWLING COPTER
Locate the battery underneath the unit. Carefully disconnect the power cable underneath the
Turbo Runner as shown in the photo. Do not pull the battery by the wires as the wires may break
off of the battery housing.
Connect the battery's power cable to the end of the USB charging cable. Then connect the USB
end of the charging cable to a USB port like on a computer or a USB phone charger.
Please note: Not all USB ports provide power. Typically, only ports mounted on a computer and
not through a peripheral will provide enough power for charging.
CAUTION
The battery may be hot if being disconnected
right after use. If hot, then wait a few
minutes to let the battery cool down. When
charging do not leave the battery unattended
to keep from overcharging. Overcharging the
battery will lead to battery damage
NOTICE
When charging with the included USB cable
the LED light will light up red, indicating it is
charging. Once charging is complete, the LED
light will turn off.
WE RECOMMEND!
The FLX Crawling Copter battery comes partially charged and is ready to fly. Skip to Remote
Control Battery Installation section and use your Quadcopter now. Use this charge completely
before charging the FLX Crawling Copter battery for the first time.
NOTICE
If the Turbo Runner is not going to be used for extended periods of time, please disconnect
the battery from the Quadcopter to avoid damage to the battery or the Quadcopter unit.
.