FGZ000UF2 BLOCK DIAGRAM SYNTHESIZER UNIT ELECTRIC UNIT (X25- ) (X14- ) (B/3)(C/3) (X14- ) (A/3) J803 (B/3) V-SYNC Q26,28 IC22 1-16PIN +B VOLTAGE DET IC2,3 F800 CONNECTOR DOT CLOCK DATA IC18 INPUT SIGNAL REG. 2. +BATT BU5V PROTECTION GENERATOR GRAPHIC...
Page 3
FGZ000UF2 COMPONENTS DESCRIPTION SYNTHESIZER UNIT (X14-9490-10) Ref. No. Application / Function Operation / Condition / Compatibility Backup 5V voltage monitoring. Resetting system µ-com at B.U OFF. Reset IC E2PROM Memory for reception TV station and touch panel compensation. CAN transceiver Communication with vehicle unit.
Page 4
FGZ000UF2 COMPONENTS DESCRIPTION Ref. No. Application / Function Operation / Condition / Compatibility Q70,71 Low voltage power supply 7.5V power supply SW (ACC : ON). Q700~702 Audio connection detection When audio is connected, Q700 is ON. Q800 Parking detection ON when vehicle is parking.
Page 5
FGZ000UF2 COMPONENTS DESCRIPTION Ref. No. Application / Function Operation / Condition / Compatibility IC203 Chroma decoder gamma compensation Conversion of input video signal into signal suitable for LCD input. IC205 E2PROM I2C memory backup. IC207 Ope amp V-COM buffer. IC209 Buffer with 3 circuits Synchronization signal output buffer.
Page 6
FGZ000UF2 MICROCOMPUTER’S TERMINAL DESCRIPTION SYSTEM µ-com : IC22 (X14 : SYNTHESIZER UNIT) Pin No. Pin Name Application Processing Operation Description NAVI-TXD Transmission data output for normal NAVI communication H, L output Not connected Not used ILL PWM ILLUMI PWM input (Cycle)
Page 7
FGZ000UF2 MICROCOMPUTER’S TERMINAL DESCRIPTION Pin No. Pin Name Application Processing Operation Description SHCLK Clock output (For video control processing) H, L output SYSCS Transmission request output (For video control processing) H, L output, L : Transmission request SHCS Clock input (For video control processing)
Page 8
FGZ000UF2 MICROCOMPUTER’S TERMINAL DESCRIPTION Pin No. Pin Name Application Processing Operation Description NAVI ON NAVI voice MUTE BEEP ON BEEP sound signal Not connected Not used KEYDET Key terminal connection detection H, L input, L : Detection Not used Not used...
Page 9
FGZ000UF2 MICROCOMPUTER’S TERMINAL DESCRIPTION Pin No. Pin Name Application Processing Operation Description Not connected Not used VREF Reference voltage input VCC5V AVCC Power supply input VCC5V NAVI-RXD Normal NAVI communication reception data input H, L input GRAPHIC µ-com : IC12 (X25 : ELECTRIC UNIT) Pin No.
Page 10
FGZ000UF2 MICROCOMPUTER’S TERMINAL DESCRIPTION Pin No. Pin Name Application Processing Operation Description ROM RY/BY Not connected L-output Not connected L-output H : Not used as transfer strobe is not used. DACK Q2i DMA transfer strobe output L-output Not connected L-output Ground input L : Not used as transfer request is not sued.
Page 11
FGZ000UF2 MICROCOMPUTER’S TERMINAL DESCRIPTION Pin No. Pin Name Application Processing Operation Description Switching output for touch panel input H, L-output Switching output for touch panel input H, L-output Switching output for touch panel input H, L-output Ground input KEYDATA1 Touch panel data input (Y)
Page 12
FGZ000UF2 MICROCOMPUTER’S TERMINAL DESCRIPTION GRAPHIC CONTROLLER : IC4 (X25 : ELECTRIC UNIT) Pin No. Pin Name Processing Operation Description DREQ DMA request 2, 3 D0, D1 CPU data CVCC1 Power supply CPU data CGND1 Ground 7~11 D3~D7 CPU data CGND2...
Page 13
FGZ000UF2 MICROCOMPUTER’S TERMINAL DESCRIPTION Pin No. Pin Name Processing Operation Description VCC3 Power supply MD15 Memory data Memory write pulse 85, 86 MRAS0, MRAS1 Lower selection signal MLCAS Lower column selection signal MUCAS Lower column selection signal GND6 Ground Memory read pulse...
(Opening Screen) appears on the screen. vice, the start position adjustment in the screen display only After the display of opening screen, the screen will display will be used. test items. MODE MENU (KENWOOD) TEST MODE MENU (KENWOOD) SCREEN(G) STATUS SCREEN(A) NAVI REAR...
Page 15
FGZ000UF2 TEST MODE Item Screen Operation Specification Remarks q Adjustment screen in input through NAVI POSITION (NAVI) NAVI Adjustment (Initial C) q Screen position Right/Left keys are made with graphics, input. adjustment which shifts the screen to right and left.
Page 16
FGZ000UF2 TEST MODE Item Screen Operation Specification Remarks q White 100% input, with NAVI (RGB) input. NIGHT NAVI (RGB) NAVI screen, with minimum brightness set. Contrast → Default q Night screen No OSD Tint → Default brightness Color depth → Default...
Page 17
When this mode is set, the item selection screen is displayed. Items for which the keys are depressed will be selected. Note: Use only video adjustment (VIDEO ADJ). Other modes are not used for servicing. TEST MODE MENU (KENWOOD) MODE MENU (KENWOOD) BRI MEASUR STATS...
Page 18
FGZ000UF2 ADJUSTMENT VIDEO UNIT (X35-4252-71) • Start a set in test mode at the time of video board adjustment. • How to enter to test mode : Pushing operation of 2 keys right (clock)-and-left (image adj.) both ends side and a touch panel. And supply to power is ON.
Page 19
FGZ000UF2 ADJUSTMENT Adjustment Adjustment item The adjustment method Adjustment value Conditions Test point part Bright Carry out the monitor of the waveform of TP527 2.5V±0.1V Incoming signal : TP527 adjustment with an oscilloscope. 10 STEP (NTSC) Adjst the amplitude value so that the waveform...
Page 20
FGZ000UF2 ADJUSTMENT Adjustment Adjustment item The adjustment method Adjustment value Conditions Test point part R sub contrast Carry out the monitor of the waveform of TP528 CH14 2.2V±0.1V Incoming signal : TP528 with an oscilloscope. 10 STEP (NTSC) Adjst the amplitude value so that the waveform...
Page 29
TP947 KEY-IN2 TP948 TP949 TP950 TP951 TP952 16 15 14 13 WH800 CN805 FGZ000UF2 (1/4) (X14-9490-1x) UNIT MODEL NAME FGZ000UF2 0-10 X35- FGZ203UF2 0-11 • DC voltages are as measured with a high impedance voltmeter. Values may vary slightly due to variations between individual instruments or/and units.
Page 40
(refer to parts list). GND LINE B LINE Indicates safety critical components. B LINE To reduce the risk of electric shock, leakage-current or resistance mea- FGZ000UF2 (4/4) surements shall be carried out (ex- (X35-425x-xx) ,205 2SC4081 Q203 2SC4097 RB060L-40...
FGZ000UF2 PARTS LIST New parts Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No. werden nicht geliefert. Desti- Desti- Ref. No. Parts No. Description Ref. No.
Page 43
FGZ000UF2 PARTS LIST SYNTHESIZER UNIT (X14-9490-10) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation C237 CK73GB1H103K CHIP C 0.010UF K C870-877 CC73GCH1H221J CHIP C 220PF C239 CK73EB0J106K CHIP C 10UF C878,879 CK73GB1H152K CHIP C...
Page 44
FGZ000UF2 PARTS LIST SYNTHESIZER UNIT (X14-9490-10) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation RK73GB2A473J CHIP R J 1/10W R241 RK73GB2A561J CHIP R J 1/10W RK73GB2A473J CHIP R J 1/10W R245 RK73GB2A472J CHIP R 4.7K...
Page 45
FGZ000UF2 PARTS LIST SYNTHESIZER UNIT (X14-9490-10) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation R331 RK73GB2A221J CHIP R J 1/10W R802-804 RK73EB2E102J CHIP R 1.0K J 1/4W R332 RK73GH2A223D CHIP R D 1/10W R805,806...
Page 46
FGZ000UF2 PARTS LIST SYNTHESIZER UNIT (X14-9490-10) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation MA3047-H ZENER DIODE IC22 M30835FJGP9R4 MICROCONTROLLER IC HZS161L ZENER DIODE IC23 TC7WHU04FU MOS-IC HZM16N(B2) ZENER DIODE IC800 TDA8579T-T ANALOGUE IC...
Page 47
FGZ000UF2 PARTS LIST SYNTHESIZER UNIT (X14-9490-10) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation Q803-806 2SC4081 TRANSISTOR C125-133 CC73GCH1H330J CHIP C 33PF Q807 DTA143EUA DIGITAL TRANSISTOR C136-141 CC73GCH1H330J CHIP C 33PF Q808 2SC4081 TRANSISTOR...
Page 48
FGZ000UF2 PARTS LIST ELECTRIC UNIT (X25-9410-11) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation RK73GB2A103J CHIP R J 1/10W HD64412FI MOS-IC RK73GB2A103J CHIP R J 1/10W MSM5118165FP60 DRAM IC RK73GB2A102J CHIP R 1.0K J 1/10W...
Page 49
FGZ000UF2 PARTS LIST VIDEO UNIT (X35-4252-71) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation C204,205 C92-0671-05 ELECTRO 10UF 16WV C307-310 CK73GB1H102K CHIP C 1000PF C206 CK73FB1C105K CHIP C 1.0UF C313-318 CK73GB1H102K CHIP C 1000PF...
Page 50
FGZ000UF2 PARTS LIST VIDEO UNIT (X35-4252-71) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation R92-3359-05 CHIP R F 1/2W R221 RK73GB2A103J CHIP R J 1/10W R92-0365-05 CHIP R 1.0K J 1/2W R222,223 RK73GB2A222J CHIP R 2.2K...
Page 51
FGZ000UF2 PARTS LIST VIDEO UNIT (X35-4252-71) Desti- Desti- Ref. No. Parts No. Description Ref. No. Parts No. Description nation nation 2SB1203-FA TRANSISTOR DTA124EUA DIGITAL TRANSISTOR DTC124EUA DIGITAL TRANSISTOR 2SC4081 TRANSISTOR 2SA1576A TRANSISTOR 2SJ327Z Q35-37 2SD1803 TRANSISTOR DTA124EUA DIGITAL TRANSISTOR DTC124EUA...
General Operating voltage ................... 13.2V DC (10.8~15.6V) KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice. Although the effective pixels for the liquid crystal panel is given as 99.99% or more, 0.01% of...