pro user APB100 Manual page 4

Wireless rear view camera system with mirror display with built-in 3,5 inch monitor
Table of Contents

Advertisement

Available languages

Available languages

3. Mount the license plate on the license plate bracket.
4. Choose a routing path for the camera's power cable through the vehicle's body to the
reverse light circuit. If in doubt, seek professional installation assistance.
5. Some vehicles may have a hole available to pass the wire through, such as where the
license plate light is mounted, or you can drill a hole close to where the power cable
is attached to the camera. Once you have chosen where the cable will enter the
vehicle's body, remove the camera. If you are able to use an existing opening, skip
the next two steps.
6. Before you drill a hole you MUST CHECK and see WHAT IS BEHIND WHERE YOU ARE
DRILLING. If there are any vehicle components, such as electrical parts or fuel
system components behind where you are drilling, you must take whatever
precaution is necessary not to damage them. Remove the license plate and camera
before drilling.
7. After you have drilled the hole, insert the supplied grommet, then pass the camera
cables through the grommet into the vehicle. You must use the grommet to prevent
the metal edge of the hole from cutting the camera cable.
8. Mount the transmitter box inside the trunk. Connect the camera's power cable and
the transmitter box power cable to the transmitter box.
9. Next you'll need to find the vehicle's reverse lights. Turn the vehicle's ignition key to
the accessory position, engage the parking brake and put the car in reverse. Look at
the vehicle's tail lights to see where the reverse lights are located, they are the white
lights. To locate the reverse light's 12V+ wire it will be necessary to gain access to
the rear of the vehicle's tail light. For help locating the vehicle's reverse light circuit
contact your vehicle's manufacturer for vehicle specific wiring diagrams.
10. Once you have located the reverse light circuit you will have to route the transmitter
box power cable to that location. You must securely fasten the power cable to prevent
it from being caught on any vehicle component such as the trunk hinge. Never route
the cable on the outside of the vehicle!
4

Advertisement

Table of Contents
loading

Table of Contents