Using Your Remote Control When The Stb Mode Is Selected - Philips Cineos DCR 9000 User Manual

6 Using your remote control when the STB
mode is selected
EN
- Open info banner
- Then show extended programme
information
- Then close banner
SELECT
Select the STB,TV,VCR, DVD, or AMP
remote control mode
TEXT
In running mode: open/close teletext
RED, GREEN,YELLOW , BLUE
Colour keys
OPT (yellow)
Open the option menu for selection in
option channels or NVOD applications,
audio, teletext, and subtitles
BACK
- Recall last channel while watching
digital TV or listening to the radio
- Wake up the receiver from standby
EXIT
- Go back one step in the menu
Volume (1) +/-
Turn the volume of your Philips TV set
up/down
Mute (1)
Audio mute on your Philips TV set
P+/P-
- Select next/previous channel
- Wake up the receiver from stand-by
Audio selection
SUBTITLE
Subtitle selection
MENU
Open/Close menu
V-Format
Switch between picture resolutions
(1) If you have a TV set other than Philips, refer to paragraph 15.3 to change the brand setting of your remote control.
Infrared interference on external devices
To avoid bad remote control reception, place your external devices out of sight of the ambient lights of your TV set.
62
Standby
- Switch to Stand-by
- Switch to Low Power (key press more than
2 seconds)
page up/down in lists
LIST
- Open current channel list
- Then switch between favourite lists
- Wake up the receiver from stand-by
EPG
Open/Close the Electronic Programme Guide
(EPG)
CURSOR keys
t/y
Move selection up/down within menus and
lists
u/ i
Select value for a setting
OK
- Call up current channel list while watching
digital TV or listening to the radio
- Select/confirm in menu
0-9
- Select a channel in digital TV mode.
- Directly select a menu item
- Wake up the receiver from stand-by
TV/RADIO
- Toggle between digital TV and digital Radio
- Wake up the receiver from stand-by
(movie expand)
Control TV display format
TIMER
Set a recording timer from the EPG
Note: press TIMER then 0 to delete the active
timer.
V-Output
Switch between output sources (HDMI or
DVI/YPbPr/SCART)