Product Handling; North-American Regulations - Philips BDP9000 User Manual

Product handling

WARNING
• TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE
COVER (OR THE BACK). NO USER-SERVICABLE PARTS ARE INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
• THIS UNIT EMPLOYS A LASER. DUE TO POSSIBLE EYE INJURY, ONLY A
QUALIFIED SERVICE PERSON SHOULD REMOVE THE COVER OR ATTEMPT
TO SERVICE THIS DEVICE.
• TO PREVENT DAMAGE WHICH MAY RESULT IN FIRE OR ELECTRIC SHOCK
HAZARD, DO NOT EXPOSE THIS APPLICANCE TO RAIN OR MOISTURE.
• TO PREVENT THE SPREAD OF FIRE, KEEP CANDLES OR OTHER OPEN
FLAMES AWAY FROM THIS PRODUCT AT ALL TIMES
• BEFORE YOU CONNECT THE PRODUCT TO A POWER SUPPLY, MAKE SURE
THAT THE VOLTAGE ON THE TYPE PLATE OF THE PRODUCT IS THE SAME
AS THE VOLTAGE OF THE POWER SUPPLY. WHEN THE VOLTAGES ARE
NOT THE SAME, REFER TO YOUR DEALER
• TO REDUCE THE RISK OF ELECTRIC SHOCK, MAKE SURE THAT THE
PRODUCT AND THE OTHER COMPONENTS ARE TURNED OFF BEFORE
YOU CONNECT OTHER COMPONENTS TO THE PRODUCT.
• DO NOT PUT YOUR HAND IN THE DISC TRAY. IF YOU DO, YOU CAN GET
STUCK IN THE DISC TRAY.
CAUTION
• ONLY LOAD DISCS WITH REGULAR SHAPES INTO THE PRODUCT. DISCS
WITH IRREGULAR SHAPES CAN DAMAGE THE PRODUCT.
• DO NOT BLOCK THE VENTILATION OPENINGS. MAKE SURE THAT THERE
IS ALWAYS AT LEAST 4 INCHES (10 CENTIMETERS) OF FREE SPACE
BETWEEN THE REAR PANEL OF THE PRODUCT AND ANY OTHER OBJECT.
• ONLY LOAD PLAYABLE DISCS INTO THE PRODUCT. DISCS THAT
CANNOT BE PLAYED OR OTHER OBJECTS CAN DAMAGE THE PRODUCT.
• DO NOT MOVE THE PRODUCT WHILE A DISC IS BEING PLAYED. IF YOU
DO, YOU CAN DAMAGE THE PRODUCT AND THE DISC.

North-American regulations

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
EN
9