Norcold DE-541 Owner's Manual page 6

to do so can result in damage to the refrigerator or other
12 volt DC appliances.
Figure 4
Lower Flange Installation
The lower flange is shipped as a loose part to prevent
damage during shipment. The part is attached after the
refrigerator is set into the cut-out opening.
1. Install the lower flange by maneuvering it under
and behind the bottom hinge plate, as shown in
Figure 5 (the hinge will be located on either the right
or left side, depending on door swing preference).
Figure 5
2. Once the lower flange is slipped around the
hinge, the part will swing into place into place as
shown in Figure 6.
3. Secure the flange with screws provided.
Figure 6
Decorative Door Panel Installation
The Norcold refrigerator door provides slots for insert-
ing a decorative panel. Installation of the panel is
accomplished by removing the handle assembly, in-
serting the decorative panel, and re-inserting the han-
dle assembly (see Figure 7).
Figure 7
The frame slots are designed to accept panel thick-
ness up to 3/16" maximum.
TABLE 3
Panel Dimensions
Door Panel
Instructions
1. Prepare panel by cutting to size indicated in
accompanying chart (see Table 3).
2. Remove handle assembly (A) by removing four
screws (B). See Figure 7.
3. Slide panel into frame slots.
4. Replace the handle assembly.
Instructions for Reversing Door Swing
Your refrigerator is equipped with convertible door
hinges. The hinging of the door can be changed to the
opposite side anytime you wish.
Tools Required
Phillips Screwdriver - Size #2
Slotted Screwdriver
Removing the Door
1. Turn the power selector switch located on the
thermostat control panel to "OFF".
2. Remove all items of food, juices, etc., from the
door.
6
DE-541
19 11/16" x 27 1/4"