Dick Smith DSLED42UHDYA User Manual page 11

c) AV (Audio/Video)
This TV provides an AV input and AUDIO output using line-level analogue stereo Audio and
composite format Video signals for compatibility with earlier accessory devices eg. VCRs,
CRT TVs, basic gaming consoles etc. Refer to page 9 regarding the specific characteristics
of these AV sockets. For optimum composite video quality, use only well shielded 75 ohm
video-grade cables.
Y Yellow (Composite video)
W
White (Audio Left)
R Red (Audio Right)
d) AUDIO
For installations where you have an existing stereo system and wish to improve your
listening experience, connect a stereo RCA cable between the AV Output L/R sockets on
this TV and the appropriate line-level inputs (eg. AUX input) on your amplifier.
For even higher quality audio signal transfer to a Sound Bar or home theatre system that
supports digital audio inputs, consider using the Coaxial Digital audio output on the TV's
side panel. Use a well shielded coax cable with RCA connectors to connect the TV to your
compatible sound equipment, and then adjust the SPDIF Mode setting in the main Sound
Menu to "PCM" if required.
NB. Take care when powering up your TV/amp combination, as there may be some click or
pop sounds on the audio output of the TV during its powering up/down phase that can be
amplified by your sound system. It is highly recommended that the TV is first powered up,
and then when its screen is active, you then power up your amplifier. When powering down
the TV/amp system, turn Off your amplifier first and then switch the TV back to its Standby
state.
W White (Audio Left)
R Red (Audio Right)
VIDEO EQUIPMENT (Composite video output)
TO VIDEO
OUTPUTS
(UHD input)
VIDEO EQUIPMENT
Y W R
TO AUDIO OUTPUTS
AUDIO AMPLIFIER (analogue input)
W R
TO AUDIO INPUTS
-11-
INSTALLATION
AV INPUT
Y
W R
AUDIO OUTPUT
L R
Coaxial
W R