Century CJW2500X SERIES Owner's Manual page 9

EXCEPTION (e), page 7:
Masonry or steel, including the damper plate, may be removed from the smoke shelf and
adjacent damper frame if necessary to accommodate a chimney liner, provided that their
removal will not weaken the structure of the fireplace and chimney, and will not reduce protection
for combustible materials to less than required by the National Building Code. Consult with local
building authorities having jurisdiction before starting.
IMPORTANT
WARNING LABEL INSTALLATION
A metal tag has been included with
your fireplace insert. This tag is to be
installed in a visible location on your
fireplace.
Using the 1/4" (6mm) carbide bit, drill
a hole 1" (25mm) into fireplace in the
desired location and hammer lead
anchor down into place. Using pan
head screw supplied, attach tag to
fireplace and tighten until secure.
Tools Required -
NOTES
1) Be sure to remove the protective plastic coating
after installing your insert.
2) Remove screws from insert body, route cord
under body and through the cut out. Attach the
blower with the screws previously removed.
Blower unit should be removed occasionally,
Inspected, and cleaned.
BE SURE TO DISCONNECT POWER
SUPPLY BEFORE SERVICING BLOWER.
3) DO NOT REMOVE
INSULATING MATERIAL
FROM FIRE BOX
BLOWER ASSEMBLY
FAN MOUNTING
SCREWS
P/N S11087- QTY 2
¼" (6mm)
Carbide drill bit
Drill
Screw Driver
O
P E
N
see note 2
P/N S31281
SPRING HANDLE
ASSEMBLY
(see page 11 for assembly)
AIR CONTROL
P/N S11008
9
FACE PLATE
P/N S31296
BRASS TRIM- TOP
*see note 1
P/N S32712
INSERT
3- PRONG GROUNDED PLUG
USE 110VAC- 15AMP
SUPPLY POWER
BRASS TRIM-
ASHFENDER *SEE NOTE
P/N S32062