Glass Care; Gasket Replacement - Century CJW2500X SERIES Owner's Manual

GLASS CARE

REPLACE GLASS ONLY WITH HIGH TEMPERATURE ROBAX PYROCERAM OF THE
PROPER SIZE AND THICKNESS
The following use and safety tips should be observed:
1. Inspect the glass regularly for cracks and breaks. If you detect a crack or break, extinguish
the fire immediately, and contact your dealer for replacement.
replacement parts list.
2. Do not slam door or otherwise impact the glass. When closing doors, make sure that logs or
other objects do not protrude to impact the glass.
3. Do not clean the glass with materials which may scratch (or otherwise damage) the glass.
Scratches on the glass can develop into cracks or breaks.
4. Never attempt to clean the glass while unit is hot. Light deposits are normal. Heavier deposits
may be removed with the use of a readily available oven cleaner.
5. Never put substances which can ignite explosively in the unit since even small explosions in
confined areas can blow out the glass.
6. This unit has an air wash system, designed to reduce deposits on glass.

GASKET REPLACEMENT

After extensive use, the sealing material which provides glass and door seal may need to be
replaced if it fails to sustain its resilience. Inspect glass and door seal periodically to ensure for
proper seal: if gaskets become frayed or worn, replace immediately. Contact your dealer for
approved replacement parts.
The following steps should be followed for glass gasket replacement:
1. Ensure appliance is not in operation and is thoroughly cooled.
2. Remove screw and glass clips (see parts diagram).
3. Lift glass out.
4. Remove old gasket and clean glass.
5. Replace new gasket starting at the bottom of glass working along edges, being sure to
center gasket channel on glass.
6. Trim to length and butt ends together.
7. Replace glass in door, being sure not to over-tighten screws and clips.
The following steps should be followed for door gasket replacement:
1. Ensure appliance is not in operation and is thoroughly cooled.
2. Remove old door gasket and clean channel.
3. Using an approved high temperature gasket cement, apply a thin coat in bottom of channel.
4. Starting at hinge side of door, work into channel around door unit, end butt and trim to
length.
5. Close door and allow three to four hours for cement to set before restarting appliance.
See page 16 of this manual for replacement parts list.
14
See page 16 of this manual for