Audiovox DT 911 Owner Operating Instructions page 6

Audiovox cordless telephone user manual
Table of Contents

Advertisement

This equipment complies with Parts 15
and 68 of the Federal Communications
Commission
(FCC) rules for the United
States.
Operation
is subject
to the
following two conditions: (1) this device
may not cause interference,
and (2)
this
device
must
accept
any
interference, including interference that
may cause undesired operation of the
device.
FCC Part 15
Warning:
Changes or modifications
to
this unit not expressly approved by the
party responsible for compliances could
void the user's authority to operate the
equipment.
The equipment
has been tested and
found to comply with part 15 of the FCC
rules.
These limits are designed
to
provide reasonable protection against
harmful
interference
in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance
with the instructions,
may cause
harmful
interference
to
radio communications.
However,there
is no guarantee
that interference
will
not occur in a particular installation.
If
this equipment
does cause
harmful
interference
to radio
or television
reception, which can be determined by
turning the equipment
off and on, the
user is encouraged
to try and correct
the interference by one or more of the
following measures:
A label is located on the underside of
the base unit containing either the FCC
registration
number
and
Ringer
Equivalence
Number
(REN).
You
must,
upon
request.
provide
this
information
to your local telephone
company.
This equipment is compatible with
inductively coupled hearing aids.
+
+
Should
you experience
trouble
with
this
telephone
equipment,
please
contact:
AUDIOVOX
COMMUNICATIONS
SERVICE
DEPT.
at (800)
229-1235.
For repair/warranty
information.
The
telephone
company
may ask you to
disconnect this equipment from the line
network
until the problem
has been
corrected.
-Reorient
or relocate the receiving
antenna.
Increase
the separation
between
the equipment
and receiver.
-Connect
the equipment
into an
outlet or on a circuit different frqm
that
to which
the
receiver
is
connected.
-Consult
the
dealer
or
an
experienced
radiofTy
technician
for help.
6
DT911
6
~
~
5115/98. 10:33 AM

Advertisement

Table of Contents
loading

Table of Contents