Table of Contents
Advertisement
Selecting the time
The timer display flashes whilst the timer is
awaiting a time selection . The timer value
can be selected between 1 and 99 minutes
touching the [+TIMER] or [-TIMER] keys,.
If the key [+TIMER] or [-TIMER] associated
with the timer is held down, the change
speed is
increased automatically. This
makes it possible to reach the desired time
setting more quickly.
Depending on the configuration of the model,
the time may be increased in increments of 1
by 1 or 5 by 5.
If the time is not selected before 5 seconds,
the timer is switched off.
If the selected time is "00" after 5 seconds
the timer is switched off.
Starting Timer Countdown
The countdown starts 5 seconds after the
last operation over the [+TIMER] or [-TIMER]
key.
A beep sounds and the timer display stops
flashing and the led heater also stops
flashing if any power level is selected.
The last minute will be displayed in seconds.
Changing the time
When the timer is in countdown the user can
change the time at any time by selecting the
heater and touching the timer [+TIMER] or [-
TIMER] key, the countdown stops and the
timer changes to time selection status
awaiting a time selection.
Timer Countdown End
When the time set on the timer has run out,
the timed heater is switched off, the timer
display and the timed heater led starts
flashing and a timer alarm beep sounds for
one minute.
Page 22
Selecting the time
Advertisement
Table of Contents
