Philips MG1100 Directions For Use Manual page 8

ENGLISH
8
3 Slide the trimming comb onto the front of the precision trimming
head and push it onto the back until it locks into place ('click').
4 Switch on the appliance.
5 Move the appliance slowly and with light pressure against the
direction of hair growth.
Note: To make trimming easier, stretch the skin with your free hand during
trimming.
Note: Make sure that the flat part of the comb always touches the skin to
obtain an even result.
Note: Do not press the appliance with the comb onto the skin too hard.
This may cause the appliance to trim the hairs shorter than the length
indicated on the comb.
Note: In areas where the hair grows in different directions, move the appliance
upwards, downwards and sideways.
6 Regularly remove cut hairs from the comb. If a lot of hairs have
accumulated in the comb, detach the comb from the appliance
and blow and/or shake the hairs out of it.
7 Switch off the appliance.
Shaving with the precision shaving head
1 Put the precision shaving head on the appliance (see section
'Attaching and detaching the attachments' in chapter 'Preparing
for use').