Makita DF010D Instruction Manual page 5

When not operating the tool, always place the lock
•
button in the locked position .
Speed change
Fig.4
To change the speed, first switch off the tool and then
slide the speed change lever to the "2" side for high
speed or "1" side for low speed. Be sure that the speed
change lever is set to the correct position before
operation. Use the right speed for your job.
CAUTION:
Always set the speed change lever fully to the
•
correct position. If you operate the tool with the
speed change lever positioned halfway between
the "1" side and "2" side, the tool may be
damaged.
Guideline for clutch auto-stop
Work range of clutch auto-stop
High speed
Clutch auto-stop works
Clutch auto-stop
does not work
When driving machine
screws
008943
Increments on adjusting
ring for fastening torque
Low speed
Increments
1 - 3
4 - 8
9 - 18
19 - 21
Do not use the speed change lever while the tool is
•
running. The tool may be damaged.
Adjusting the fastening torque
Fig.5
The fastening torque can be adjusted in 21 steps by
turning the adjusting ring so that its graduations are
aligned with the pointer on the tool body. The fastening
torque is minimum when the number 1 is aligned with
the pointer, and maximum when the
aligned with the pointer.
The clutch will slip at various torque levels when set at
the number 1 to 21. The clutch is designed not to slip at
the marking.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
1
5
9
13
17
21
Guideline for machine screw diameter
5
Fastening torque
Approx. 0.3 N m
(Approx. 3 Kgf-cm)
Approx. 0.82 N m
(Approx. 8.4 Kgf-cm)
Approx. 1.35 N m
(Approx. 13.8 Kgf-cm)
Approx. 1.88 N m
(Approx. 19.2 Kgf-cm)
Approx. 2.41N m
(Approx. 24.6 Kgf-cm)
Approx. 2.9 N m
(Approx. 30 Kgf-cm)
Low speed
Approx. 5 N m
(Approx. 49 Kgf-cm)
High speed
Approx. 1.5 N m
(Approx. 14.7 Kgf-cm)
2.5 mm
3 mm
4 mm
5 mm
marking is