LENCO PDR-030 User Manual page 8

Signal strength: The slide bar indicates how strong the signal is.
Time& Date: Displays the time and date information provided by the broadcaster.
Station information on FM mode
Every time you press the Info/Menu button in the DAB mode, the display will cycle through the
following display modes:
Radio Text: Displays scrolling test information supplied by the broadcaster.
Program type: Displays a description of the type of program provided by the broadcaster.
Signal Strength: Displays a signal bar with the strength of the current station.
Time and Date: Displays the time and the date.
Channel Frquency: This shows the frequency of the current station.
Auto (Mono or Stereo): When in FM mode, the display will show if the station being received ins in
mono or stereo.
Note: To switch between mono and stereo by pressing the Select/Snooze button repeatedly.
Retuning your DAB+/FM Radio
You can retune your radio stations to store new stations or tune to a new region. Your preset stations
will remain stored when you perform a full scan retune. In DAB mode:
Press the Scan button to perform a full scan.
Progress will be indicated on the display.
When tuning is complete, the radio will play the first listed station or return to the last station played.
Using the Headphones
You can listen to your DAB/FM radio using headphones, just plug the 3.5mm jack into the back of your
device in the headphone jack. Control the volume by using the Volume knob.
FAQs
Problem
No Power
No sound
Poor reception
Function disturbed
Solution
Check that the system is connected to a working mains outlet.
Check that the DC power adaptor is properly connected to the DC in on the
radio.
Check that the volume control is not at minimum setting.
Adjust the location of the antenna for best signal reception.
If none of the above solution work, try switching off and unplugging your Radio.
8