Eliminating Minor Faults Yourself - Siemens KG36NVW35G Manual

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
Warning signal sounds.
Temperature display flashes.
Fig. "/8
The temperature in
the freezer compartment is
too warm.
The light does not function.
22
Possible cause
Fault - the freezer
compartment is too warm!
Frozen food is at risk.
Appliance is open.
Ventilation openings have
been covered.
Too much food was placed in
the freezer at once.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
To switch off the warning signal, press the
temperature setting button, Fig. "/6.
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed max. freezing capacity.
When the fault has been rectified, the
temperature display stops flashing.
Do not open the appliance unnecessarily.
Remove obstacles.
Do not exceed max. freezing capacity.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.