Toshiba Satellite M20 Maintenance Manual page 229

4 Replacement Procedures
Next, fit the bezel's edge close to the TAB.
次にたＴＡＢ側をはめる．
ラッチ５か所をはめる．
Close the five latches.
The fold of GND-cu must not go
ＧＮＤ－ＣＵ折り曲げ有り．
beyond the bezel's edge.
ベゼルの外に出ないこと．
19. Fasten the four screws on the left edge in the order ⑤, ⑥, ⑦, and ⑧ shown in Figure
4-59.
20. Fasten the four screws on the right edge in the order ①, ②, ③, and ④ shown in Figure
4-59.
CAUTION: Fasten the screws in the orders shown in Figure 4-60. No loose fastening is
allowed.
The tightening torque must not exceed 0.147
For the Philips screwdrivers, use an insert bit of point size 0.
4-78
2
2
2
The fold of reflector must not go
リフレクタ折り曲げ有り．
ベゼルの外に出ないこと
beyond the bezel's edge.
Figure 4-59 Aligning the bezel
Ｎ･
4.20 Toshiba 14.1-inch FL
2
2
1
First, fit the bezel's edge close to the lamp.
ベゼルをランプ側からはめる．
ケーブルをキズつけないように注意
Use care not to damage the cable.
ラッチ２箇所有り．
Two latches
m (1.5kgf ･ cm) for all the eight screws.
Satellite M20 Maintenance Manual