Nesco NC5611 Steam Pro II Instruction Manual page 13

Operating Instruction
- Check the Rating informationon product, which should match with your local
supply Voltage.
-This is a 1750 watt appliance. To avoid a circuit overload, do not operate a high
wattage appliance on the same circuit.
- If an extension cord is absolutely necessary, the marked electrical rating should
be at least as great as the electrical rating of the appliance. Cords rated for less
amperage may overheat. Care should be taken to arrange the cord so that it
cannot be pulled or tripped over.
- Do not cut or attempt to extend the steaming hose.
Environment protection first!
Your appliance contains valuable materials which can be recovered or
recycled.
• Leave it at a civic waste disposal centre.
On/off switch and indicator lamp description
Garment Steamers, you can use the power switch control. Press the power
switch, Power indicator light, Garment Steamer work.Until the steam indica-
tor light.Press the pump control switch on the handle,refer to fig.16,Indi-
cator lights on the handle.Pump work.Steam started out.
When there is less water, please remember to add water.
Installation (Before use)
- Read all instructions before use.
- Remove all electrical packaging.
- Do not power or open the product before installation is complete.
- Removable subassembly of Production, refer to fig.1
- Please Telescopic pole into the bracket to the body , refer to fig.2
- Make sure the knob tight after insert into the body., refer to fig.3
- Open the buckle, pull out aluminum pole.refer to fig.4
- Locking clips,refer to fig.5
- Put steam pipe connector into the body,refer to fig.6
- Put steam handle on the bracket,refer to fig.7
12