Setting Up Jet Pro - Recon JET PRO User Manual

SETTING UP JET PRO

1. REMOVE THE BATTERY PROTECTOR TAB
Hold Jet Pro with one hand and pull the tab straight up
with the other.
2. CHARGE JET PRO
Use the included Micro-USB cable to connect Jet Pro to a
computer or charger. The status indicator LED will turn red
to indicate that Jet Pro is charging. To fully charge Jet Pro,
leave it connected for approximately one hour.
WARNING:
• Do not attempt to charge Jet Pro with the battery and/or
engine removed.
• Be sure to cover Jet Pro's Micro-USB port after charging to
prevent moisture from entering Jet Pro.
3. POWER ON JET PRO
To power on Jet Pro, press and hold the BACK/POWER
button for 2 seconds. Jet Pro's status indicator LED will turn
white. After about five seconds, the screen will turn on.
6. POWER OFF JET PRO
To power off Jet Pro, press and hold the BACK/POWER
button until "Shutting Down" appears on the screen. This
should take about 5 seconds.
To force a shutdown (not recommended), press and hold
BACK/POWER for 9 seconds.
WARNING: Do not attempt to remove Jet Pro's battery or
engine prior to a complete shutdown. This may damage your
Jet Pro permanently.
2