Troubleshooting; Adb; Battery; Support - Recon JET PRO User Manual

TROUBLESHOOTING

ADB

For help with ADB, please visit the Intel Developer Zone at https://software.intel.com/en-us/recon/jet-pro.

BATTERY

CHARGING USING A COMPUTER
1. Make sure your computer is turned on and is not in standby mode.
2. Connect Jet Pro to your computer using the included Micro-USB cable.
3. Make sure Jet Pro's status indicator LED is red. This indicates that Jet Pro is charging.
4. Charge Jet Pro until the status indicator LED goes dark. This indicates that Jet Pro is fully charged.
5. If your computer does not recognize your Jet Pro, try disconnecting and then reconnecting the Micro-USB cable.
NOTE: Under optimal conditions, Jet Pro can achieve an 80% charge after being connected to your computer for one hour. The
charging time may vary depending on your computer configuration.
WARNING:
• Using a Micro-USB cable other than the one provided may shorten battery life and, in some cases, may damage Jet Pro permanently.
• Do not attempt to charge Jet Pro with the battery and/or engine removed. This will cause permanent damage.
• Do not let Jet Pro overheat. This may cause thermal runway or explosions.
• Do not charge Jet Pro in excessively hot or cold environments (below 32°F/0°C or above 104°F/40°C).
• After charging Jet Pro, close the USB protection cap tightly to prevent water damage. If the battery looks damaged or inflated, stop
using Jet Pro immediately.
CHARGING USING AN AC WALL CHARGER
Alternatively, you can charge Jet Pro using an AC wall charger with an output of 1A and 5V.

SUPPORT

For service and support, please visit www.reconinstruments.com/support-services.

WARRANTY

Find the terms and conditions of Jet Pro's warranty at www.reconinstruments.com/warranty.

BATTERY DISPOSAL INFORMATION

In the EU, this symbol means that this product must not be disposed of with household waste. It is your
responsibility to bring it to a designated collection point for the recycling of waste electrical and electronic
equipment. For more information, please contact your local waste collection center or your point of
purchase of this product.
Visit the following link for Jet battery disposal information:
www.reconinstruments.desk.com/customer/portal/articles/843025
Jet Pro is powered by a lithium-ion battery. If you are done using the device, it should be taken to a recycling
center for proper and safe disposal.
7