Table of Contents
Advertisement
Available languages
Available languages
12
INSTALLATION
INSTRUCTIONS
Checking
and
choosing
fhe
proper
Iocafion
Install
the washing
machine
on a solid floor
that
is strong
and rigid enough
to support
the weight
of the washing
machine,
even when fully
loaded,
without
flexing
or bouncing.
If the floor
has too
much
flex, you may need to reinforce
it to make
it more rigid.
If the floor
is not solid, it may cause
severe vibration
and noise.
Clean the floor
before
installation.
- Make sure to select solid and smooth
ground.
2
Two or more
people
are needed for moving
and
unpacking
the washing
machine.
3
Allow
for sufficient
space between
the walls
and
the washing
machine
for installation.
You must allow
sufficient
space for water
lines, the
drain
line, and airflow.
_@ NOTE ........................................................................................................................................
', • Be sure to allow
for wall, door,
or floor
'
moldings
that may increase
the required
,
clearances.
\
J
_22'/4"_
I
(75.6 cm)
(
.
)
@
NOTE-
,
The floor
must
be strong
and rigid
enough
to support
the weight
of the washer,
when
fully
loaded,
without
flexing
or bouncing.
If
your
floor
has too
much
flex,
you
may need
to reinforce
it to make
it more
rigid.
A floor
that
is adequate
for a top-loading
washer
may
not be rigid
enough
for a front-
loading
washer,
due to the difference
in the
spin speed
and direction.
If the floor
is not
solid,
your
washer
may vibrate
and you
may
hear and feel the vibration
throughout
your
house.
• Before
installing
the washer,
make
sure
the floor
is clean,
dry and free of dust,
dirt,
water
and oil so the washer
feet can not
slide
easily.
Leveling
feet that can move
or
slide
on the floor
can contribute
to excess
vibration
and noise
due to poor contact
with
the floor.
• If a drip
pan must
be used,
take extra
care
to follow
the instructions
provided
with
the
drip
pan and make
sure the leveling
feet are
adjusted
for firm
and even contact
with
the
pan. Use of drip pans and failure
to properly
level the machine
may
result
in increased
vibration
and noise
during
operation.
.
/
29 3/4"
_1
1_(75.6
crn)
,_@ NOTE
i • Refer to the instructions
packaged
with
the
optional
PEDESTAL
or STACKING
KIT before
installing
with
a PEDESTAL or a STACKING
KIT.
Advertisement
Table of Contents
