Omron NS12-TS00 Setup Manual page 57

@ Errors
· During Automatic Transfer
The indicator on the front panel will flash red if an error occurs during data transfer.
Check the following items if an error occurs.
· Is the Memory Card inserted into the PT?
· Do the banks set with the DIP switch exist in the Memory Card?
(During Download)
· Is the size of the transfer data greater than the free space in the PT or Memory Card?
Check these items before transferring data again.
Reference
An error message will not be displayed if an error occurs.
· During Manual Transfer
If an error occurs during data transfer, a transfer error screen will be displayed.
Check the following items for each message displayed.
Error Messages Requiring Checking
Error message
Memory Card Error
Could not recognize a Memory Card.
Check the Memory Card and reset the NS
Hardware.
Project Transmission Error
Transmission Failed.
Check the Memory Card and reset the NS
Hardware.
System Transmission Error
Transmission Failed.
Check the Memory Card and reset the NS
Hardware.
Cannot find source data.
Are you sure to continue Download-
ing/Uploading?
After checking the message, reset the PT, and transfer the data again.
· If the system programs cannot be replaced by using automatic download or the PT
system is damaged due to a reason such as the power being turned OFF while a file is
being written, using normal downloading to replace the system program may not be
possible.
Check item
· Is the Memory Card inserted into the PT?
· Is the Memory Card damaged?
· Was the Memory Card removed during data
transfer?
· Is the free space on the Memory Card insufficient?
· Is the Memory Card damaged?
· Does the screen data volume exceed the memory
capacity of the PT?
· Does the transfer source directory or file exist?
(Note: If the Yes Button is pressed and data is
transferred, the previous data at the transfer desti-
nation will be deleted.)
3-6 Using Memory Cards
3-25