Table of Contents
Advertisement
5-1 Connecting to Host Via Ethernet
Reference
Ethernet Connectors:
This is the connector used to connect the transceiver cable to the Ethernet.
· Electrical characteristics:
· Lock structure:
This is the connector used to connect the twisted-pair cable to the Ethernet.
· Electrical characteristics: Conforms to IEEE802.3 standards.
· Connector structure: RJ45 8-pin modular connector (conforms to ISO8877).
5-10
· When using automatic generation (default method) for converting addresses, set the
same value for the node number as that set for SW7 and SW8, and set the other host
ID fields to 0. The ERC indicator will flash if the value of the IP address host ID does
not correspond to the node number value.
· Set the subnet mask in the CPU Bus Unit Setup Area using the CX-Programmer.
CS1W-ETN01
Connec-
tor Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Hood
CS1W-ETN11
Connec-
1
tor Pin
1
2
3
4
8
5
6
7
8
Conforms to IEEE802.3 standards.
Conforms to IEEE802.3 standards for Slide latches.
Signal name
Signal ground
Collision detection signal +
Send data +
Signal ground
Receive data +
Voltage common
Power ground (common
with signal ground)
Not used.
Signal ground
Collision detection signal -
Send data -
Signal ground
Receive data -
Transceiver power
Signal ground
Not used.
Frame ground
Signal name
Send data +
Send data -
Receive data +
Not used.
Not used.
Receive data -
Not used.
Not used.
Abbreviation
Signal direction
－
GND
COL+
Input
TX+
Output
-
GND
RX+
Input
-
VC
-
-
GND
COL-
Input
TX-
Output
-
GND
RX-
Input
-
VP
-
GND
-
-
-
FG
Abbreviation
Signal direction
TD+
Output
TD-
Output
RD+
Input
-
-
-
-
RD-
Input
-
-
-
-
Advertisement
Table of Contents
Troubleshooting
