Mixing Fuel - Bushranger BRV2600 Operator's Manual

Blower Assembly Instructions
Blower
• Join the two blower
tubes A & B together.
Refer to page 5.
• Fit to machine (Fig. 1).
• Rotate the tube
clockwise into locking
position (Fig. 1).
• Fit securing screw provided.
Vacuum Attachments
• Unscrew locking wing-
nut and store until
needed to close safety
cover (Fig. 2).
• Join the vacuum tubes
#1 & #2 together.
Refer to page 5. Open
the safety cover and
attach the tubes to
the machine (Fig.
3). Rotate the tube
clockwise into locking
position.

MIXING FUEL

Fuel Requirements:
• Use only fresh, clean fuel.
• Use only fuel with an octane rating of 95 or
higher.
• Mix all fuel with premium 2-cycles engine oil at
a gasoline/oil ration of 25:1.
CAUTION
Never attempt to mix fuel in the machine fuel
tank. Always mix all fuels in a clean approved
container. Some gasoline contains alcohol as
an oxy genated. Oxy genated fuels may cause
increased engine operating temperatures. Under
certain conditions, alcohol-based fuels may also
reduce the lubricating qualities of some mixing
oils. Never use any fuel containing more than
10% alcohol by volume.
6
Vacuum Bag
• Unzip the bag and place
the small end of the
elbow tube through the
hole at the opposite end.
Pull the narrow end of the
tube out of hole, until it is
Lock
held firmly in place at the
wider end (fig. 4).
Fig. 1
Attach the elbow tube to
the machine and twist
in place as per (fig. 5)
then fit and tighten the
securing screw.
IMPORTANT
Mix only enough fuel for your
immediate needs. If fuel must
be stored longer than 30 days,
it should first be treated with a
Fig. 2
stabilizer or equivalent product.
WARNING
• Danger from rotating impeller. Stop the engine
before installing or removing the machine
Lock
tubes. Never perform any maintenance or
assembly procedures on this machine while
Whenever possible use 2-cycle oil or equivalent
oil mixed at a 25:1 ratio. Be aware that generic
oils and some outboard mixing oils may be
intended for use in high-performance air cooled
2-cycle engines, and should never be used in
your engine.
WARNING
Danger of fire: Never transfer or store fuels in
the presence of combustible materials. Before
starting the engine, always move the machine to
a clear area at least 10-feet (3-metres) away form
fuels and other combustible materials.
IMPORTANT
Mix only enough fuel for your immediate needs. If
fuel must be stored longer than 30-days, it should
first be treated with a stabilizer or equivalent
product.
Fig. 4
Fig. 5
Fig. 6