10.3.2 Flashing Sequences Of The Channel Led; Restore Factory Settings - HomeMatic HmIP-FAL24-C10 Operating Manual

Restore factory settings

10.3.2 Flashing sequences of the channel LED

Flashing code
Slow flashing
Short double
flashing
11 Restore factory settings
The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the floor heating actua-
74
Meaning
Emergency
operation
activated
Radio
connection to
wall thermostat
failed
Solution
Change batteries
of the wall
thermostat,
perform a
communication
test, re-position
the wall
thermostat (if
required), replace
wall thermostat if
defective
Re-position wall
thermostat or add
a repeater (see sec.
„10.1 Command
not confirmed" on
page 70).