Configuration Via The Homematic Ip Wall Thermostat - HomeMatic HmIP-FAL24-C10 Operating Manual

• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the QR
code. Therefore, please see the sticker supplied or
attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED lights up
green. The device is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate it
to a room.
7 Configuration via the
Homematic IP Wall Thermostat
The Homematic IP Floor Heating Actuator can be
configured via the Homematic IP Wall Thermo-
stat (HmIP-WTH-2), via the Homematic IP Access
Point together with the smartphone app or via
the WebUI of the Homematic Central Control
Unit CCU2.
To configure the floor heating actuator using the wall
thermostat, please proceed as follows:
• Press and hold down the control wheel of the
wall thermostat to open the configuration menu.
• Select the
wheel and confirm by pressing the control wheel

Configuration via the Homematic IP Wall Thermostat

symbol by turning the control
61