5
Mounting
For operation of the floor heating actuator with
24 V, a 24 V/50 Hz power supply is required. We
recommend you to use the Homematic IP Trans-
former for Floor Heating Actuators – 24 V (HmIP-
FAL24-TR).
When
using
in
combination
Transformer for floor heating actuators - 24 V
(HmIP-FAL24-TR), it is recommended to install the device
on the supplied DIN rail. For mounting the floor heating
actuator and the transformer to a DIN rail, please proceed
as follows:
•
Please select a suitable mounting location close
to your heating manifold.
Make sure that no electricity or similar lines run in
the wall at this location!
•
Use a pen to mark two bore holes for mounting
the DIN rail on the wall.
•
Use an appropriate drill to make the holes as illus-
trated.
•
Fasten the screws and plugs supplied to mount
the DIN rail.
•
Place the floor heating actuator onto the DIN rail
(see fig. 3).
the
floor
with
heating
the
Homematic
Mounting
actuator
IP
51