Burst Mode; To Enable Burst Mode; To Disable Burst Mode Hold Down The Right Trigger - GamerModz xbox One – SPS-X3 Instruction Manual

Burst Mode allows you to set the number of shots fired with each trigger pull. Your GamerModz SPS-X3
Controller comes with 4 Settings for Burst Mode.
To enable Burst Mode - Rapid Fire must first be enabled (See Page 2 "Toggle Between Rapid Fire Modes") –
Hold Down the Right Trigger
Burst Mode below. Then Release the Right Trigger
times corresponding to the mode selected, indicating that Burst Mode has been toggled on.

To disable Burst Mode Hold Down the Right Trigger

Release the Right Trigger
has been toggled off.
Hold
MODE 2 ----------------- X
MODE 3 ----------------- X
MODE 4 ----------------- X
MODE 5 ----------------- X
TURN OFF -------------- X
Notes:
You must have Rapid Fire Enabled to Enable Burst Mode. If Rapid Fire is not Enabled, Enabling Burst
-
Mode will fail.
Gameplay Tips:
Combine Burst Mode with a Weapon's Optimal Max Fire Rate to increase accuracy and save on Ammo.
-
MODE 3 ----------------- X
MODE 4 ----------------- X
MODE 5 ----------------- X
GamerModz

Burst mode

and Tap Up on the D-Pad
. The XBOX One Controller LED will flash one time to indicate that Burst Mode
Tap
, then
2
3
4
5
6
3
4
5
XBOX One – SPS-X3 Ver 3.0
the number of times corresponding to the
. The XBOX One Controller LED will flash the number of
and Tap Up on the D-Pad
Mode #, then
X
2
ROUND BURST
3
ROUND BURST
4
ROUND BURST
5
ROUND BURST
DISABLE
BURST MODE
CUSTOM
CUSTOM
CUSTOM
6 or More times, then
Release
6