Whirlpool ET22DK Use & Care Manual page 6

Adjusting the refrigerator shelves...
Shelves can be adjusted to match the way you use
your refrigerator. Glass shelves are strong enough
To remove glass shelves:
to hold bottles, milk and other heavy food items.
1. Tilt up at front.
2. Lift up at back.
GLASS SHELVES ARE
HEAVY. BE CAREFUL.
3. Pull shelf straight out.
To replace glass shelves:
1. Guide the rear hooks into the slots in the shelf
supports.
2. Tilt up front of shelf until hooks drop into slot.
Lower front of shelf to level position.
Removing freezer shelf...
1. Lift front slightly.
2. Lift back off supports.
3. Replace in reverse order.
LlFl THE FRONT
THEN THE BACK
Adjusting the door shelves...
TO remove door shelves:
To
replace door shelves:
1. Lift up shelf.
2. Tilt up at front.
3 PI 111 ch=rf straight out.
1. Tilt up front of shelf until
hooks fit into slots in the
shelf support.
2. Lower front of shelf to level
position.
3. Push shelf down.
,P I_
!,.:
Removing crispers and crisper co;eri::
r%.- 1 .-~~I*---~ i a'
Li, nyr& :pIRhvli
PULL OUT TO STOP, LIFT THE FRONT
AND PULL AGAIN
REMOVE THE
GLASS IS HEAVY.
BE CAREFUL.
To remove the crispers:
1. Slide crisper straight out to stop, lift front, then
slide the rest of the way out.
2. Replace in the reverse order.
To remove the cover:
1. Push up glass insert from bottom, then slide out
with both hands.
2. Lift front of cover frame.
3. Lift out cover frame by pulling up and out.
4. Remove metal cover support.
To replace the cover:
1. Replace metal cover support on wall supports
in front section of cabinet.
2. Fit back of corner into notch supports on walls of
refrigerator, then lower into place.
3. Slide back of glass insert into place, then lower
front.