Propeller Replacement - Duramaxx 90010 Owner's Manual

PROPELLER REPLACEMENT

• Hold the propeller and loosen the prop nut with a pliers or a wrench.
• Remove prop nut and washer.
NOTE: If the drive pin is sheared/broken, you will need to hold the shaft steady with a
screwdriver blade pressed into the slot on the end of the shaft.
• Turn the old prop to horizontal (as illustrated) and pull it straight off. If the drive pin
falls out, push it back in.
• Align new propeller with drive pin.
• Install prop washer and prop nut.
• Tighten prop nut 1/4 turn past snub. (25-35 inch lbs.)
IMPORTANT:
cause too much pressure/strain on the motor which may cause overheating or premature
battery drain.
CAUTION:
Disconnect the motor from the battery before beginning any prop work
or maintenance.
Weedless Propeller
Prop nut
PROPELLER REPLACEMENT
If the prop nut is overtightened it may cause damage to the prop or
Washer
10
Slot End
Drive pin