Page 2
Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
Congratulations on your purchase of the IDC™ 150T space, solid state, mono power amplifier capable of delivering more than 150 W RMS. The unit has been designed to be reliable, meeting the needs of most fixed installation applications. One of the most significant features of this amplifier is its battery backup capability.
Page 4
This terminal strip is provided to drive the input of other amplifiers. It is a balanced 600 ohm line output. MATRIX (10) This jack is to be used with Peavey’s MediaMatrix system. This allows for remote status and control of the amplifier or several amplifiers.
If within one (1) year from date of purchase a properly installed product proves to be defective and Peavey is notified, Peavey will repair or replace it at no charge. (Note: Batteries and patch cords not covered.) “Original purchaser”...
Rated Output Power: (typical value) AC powered, continuous sine wave: 70 volt line 32.7 ohms, 1 kHz, 1% THD: 150 W RMS 25 volt line 4.2 ohms, 1 kHz, 1% THD: 150 W RMS 24 V DC battery powered, continuous sine wave: 70 volt 32.7 ohms, 1 kHz, 1% THD: 100 W RMS 25 volt 4.2 ohms, 1 kHz, 1% THD: 100 W RMS Frequency Response: (typical value)
16. The user should not attempt to service this equipment. All service work should be done by a qualified service technician. 17. This product should be used only with a cart or stand that is recommended by Peavey Electronics. 18. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time.