Adjustment Of The Anti-Tip Device; Adjustment Through The Rotation Of The Support Plate; End Terminal Adjustment - OFF CARR ALHENA Instruction Manual

5.2 Adjustment of the anti-tip device

The position of the anti-tip is defined during the assembly. However is possible to change its distance from ground if
necessary.
5.2.1

Adjustment through the rotation of the support plate

Loosen without removing the screws "A";
Rotate the anti-tip support until the desired distance of the
small wheel from the ground is reached;
Properly tighten the screws "A".
5.2.2

End terminal adjustment

Remove the screw "B";
Move the telescopic end terminal until the small wheel is in
the right position;
Insert the screw "B" and fix it properly.
19