Table of Contents
Advertisement
Press ▲/▼ to move the cursor onto an option. Press OK and press ◄/► to adjust the value. Press
1.2
Back to quit the menu.
Note: This menu is only available when TV signal source is used.
ECO Mode
Press ECO on the remote controller to enter the ECO mode (ECO-Auto-Standard). Press this button to switch
among the three modes.
The power consumption will be halved under the ECO mode.
Under the Auto mode, the display will automatically adjust the brightness of the screen according to
the light from the environment. When the surrounding light is high, the screen will increase in
brightness. When the surrounding light is lower, the screen will decrease in brightness.
Under the Standard mode, the screen brightness will stay the same.
Note: To save energy, please switch off the panel when it is not being used; and switch the panel to Alone when you do not
need to watch the display, thus cutting power consumption.
Serial Port Control
The RS-232 port of the interactive panel is defined as follows:
Connect RS-232 port to the PC or controlling device. Enable RS-233 serial port connection and complete the
57
Advertisement
Table of Contents
