Optional Accessories - Fakir Multiplex Instruction Manual

Press button to the release the multifunction head
•
and raise it to a vertical position.
Fit the bowl onto the appliance by turning untit
•
locks in position and place the ingredients in it,
weighting them as indicated under the weighing
function.
•
Position the cover on the head with the filling
opening at the front of the appliance.
•
Fit the desired accessory in the power outlet,
pushing the shaft of the accessory home and turn
it a quarter turn towards you to lock it in position.
Lower the multifunction head of the appliance to
•
horizontal position and press button again (a click
should be heard).
During preparation, you can add ingredients
•
through the opening the cover.
• To stop the appliance, turn the knob back to "0"
position.

Optional accessories:

a-Using with the blender attachment:
Depending on the nature of the ingredients, the
•
blender can be used to prepare up to 1.4L of
mixture.
Assembling and fitting the attachment.
Assemble the blade assembly to the seal and lock
•
it with a quarter turn clockwise into the bottom of
the jug (the jug must be upright).
Lower the multifunction heard of the appliance to
•
a horizontal position and press release button
again (a click should be heard).
Press release button for cover to open the cover.
•
Ensure that the appliance is at a standstill before
•
latching on the assembled blender.
Fit the assembled blender and lock it in position
•
by turning it anticlockwise.
Place the ingredients in the blender jug, weighing
them as indicated under the weighing function
and then fit the cover with the measuring plug.
CAUTION
CAUTION
• Do not run the blender empty for more than 1
minute.
• Never fill the mixing jug with boiling fluids, you
could allow these to cool down to a room
temperature. Otherwise, the appliance could
overheat and the glass of the mixing jug could
crack. • When you use the jug operate ice, you
could select nine ices each time and the every ice
size is 40MM * 40MM * 20MM.
b-Using with the meat grinder attachment:
Assembling and fitting the attachment;
• Insert the worm shaft into the cutter housing, the
plastic end first. Place the cutter unit onto the worm
shaft. (The cutting edges should be at the front.)
Place the fine grinding disc or coarse grinding disc
(depending on the consistency you prefer) onto the
warm shaft. (Make sure the notch of the grinding
disc fit onto the projections of the mincer head.) Turn
the screw ring in the direction of the arrow on the
cutter hosing until it is properly fastened.
05 09