Module Jig Service Concept - Nokia 6260 RM-25 Service Manual

Nokia Customer Care
Item
4
5
6
7
8
9
Note: More than 32MB SRAM required in FPS-8.

Module jig service concept

This concept is for troubleshooting and RF calibration.
MJ-30 is intended for use with an external power supply.
MJ-30 input voltage: normal +6V, maximum +12V.
Ensure that the jumper is set open for voltage regulation before the external power supply is connected.
When FPS-8 is used as the power supply (4V), the jumper should be set close to bypass regulator.
EM calibrations including Zocus are only done with JBV-1. Module jig MJ-30 does not support Zocus calibration
in RM-25.
Item
1
2
3
Page 3–38
Description
Flash prommer box sales
pack
Printer cable
D9 – D9 cable
Software protection key
AC Charger
SRAM Module (3 pcs
needed inside FPS-8)
Figure 72 Module jig service concept
Description
Module jig
RF cable
Power cable
Company Confidential
Copyright ©2005 Nokia. All Rights Reserved.
Type
FPS-8
AXP-8, included in FPS-8
sales pack
AXS-4, included in FPS-8
sales pack
PKD-1
ACF-8, included in FPS-8
sales pack
SF12
Type
MJ-30
XRF-1
PCS-1
RM-25
Phoenix service software
Code
0080321
Not available as spare
part
0730090
0750018
0680032
0080346 (Code includes
one SRAM module)
Code
0780376
0730085
0730012
9235618 (Issue 2)