Preparing For Transmitter Troubleshooting - Nokia 6260 RM-25 Service Manual

RM-25
RF troubleshooting

Preparing for transmitter troubleshooting

Steps
1. Place the phone (mechanics removed) on module jig.
2. Connect the module jig to PC via a DAU-9P cable.
3. Connect the module jig to a power supply (4.2V).
4. Connect the RF output to a spectrum analyzer or another measurement instrument. Use a 10dB attenuator
at the input to spectrum analyzer to avoid damaging it.
5. Make sure the dongle is connected and start Phoenix.
6. In Phoenix, choose: File -> Open Product -> RM-25 Product Menu.
7. Select Testing -> RF Controls.
8. In the toolbar: set Operating Mode to Local.
9. Select Band: GSM900, GSM1800 or GSM1900.
10. Set Operation Mode to Burst.
11. Set Active Unit to Tx.
12. Set Tx Data Type to All 1.
13. Set Rx/Tx Channel to 37 for GSM900, 700 for GSM1800, or 661 for GSM1900.
14. Set Tx PA Mode to Free.
15. Set Tx Power Level to 5 for GSM900, otherwise to 0.
9235618 (Issue 2)
Figure 123 Upper and lower shielding cans
Company Confidential
Copyright ©2005 Nokia. All Rights Reserved.
Nokia Customer Care
Page 7–23