Transportation - RMS Simba User Manual

TRANSPORTATION

The SIMBA Buggy has been successfully tested to ISO 7176-19
(Wheeled mobility devices for use in Motor Vehicles)
The restraint systems used for the buggy and occupant during the above testing are
available from:- Unwin Safety Systems.
C.N. Unwin Ltd., Unwin House, The Horseshoe, Coat Road, Martock, Somerset, TA12 6EY.
Tel: 01935 827740 Fax: 01935 827760
Email: sales@unwin-safety.co.uk Web: www.unwin-safety.com
Part numbers:-
Buggy tie-downs: Front—OF03 Rear—OR02
Occupant restraints: OCR02
These kits meet the requirements of ISO 10542 (Wheelchair Tie-downs and Occupant
Restraint Systems).
If the intended transporting vehicle is not already fitted with Unwin type anchorage
tracks, details of these can also be obtained direct from Unwin Safety Systems Ltd.
NOTE: Installation and use of all restraint systems should always be strictly as per the
their manufacturers recommendations.
The Buggy restraints must only be attached to the indicated tie-down points shown
below.
IMPORTANT NOTE:
THE SIMBA and OCCUPANT MUST ONLY BE TRANSPORTED IN THE
FORWARD FACING, FULLY UPRIGHT POSITION.
Front Tie-down
Rear Tie-down
points points