Ten Haft samysolar Installation Instructions Manual page 37

Example: The vehicle is equipped with a lead-gel battery. The battery's voltage is
monitored by the total-discharge protection function. If no signal shall
sound in the event of a total discharge:
Jumper 1:
Jumper 2:
E
Jumper 3:
(Please see the product information sheet in the package of the Solara SR 135 charge controller for
more details.)
Install the charge controller near the battery, if possible, using the two screws.
The connections to the onboard electric system are now complete.
You must now test the safety function:
a) Press button
open.
b) When the external unit is about upright, interrupt the motion by pressing .
c) Switch on the vehicle ignition.
d) Verify by visual check that the external unit retracts.
closed
closed
Open
to turn on the control panel. The external unit must now
37