Sharp AR-RP1 Service Manual page 4

9) Remove the PWB shield plate.
Remove the six screws.
10) Install the SPF harness and the ring core (included together with
the unit).
Pass the SPF harness through the plate hole from the above and
fix it to the plate with the supplied two hex cap screws. ( )
Pass the SPF harness through the ring core ( ), and connect it to
the main PWB connector (CN11) inside the copier. ( )
Be careful about the direction of the connector.
1
3
2
11) Install the interface harness.
Connect the interface harness from the SPF to the machine and
tighten the screws.
12) Remove the filament tape.
Remove the filament tape at four positions.
13) Install the intermediate tray in the case of RSPF.
In the case of RSPF, install the intermediate tray by pushing it to
the inner part.