Front Panel - Peavey TRANSTUBE 110 EFX Operation Manual

Front Panel

13 13
6 7 10 8
Input jack will accept signals from all types of guitar pickups. Be sure to use a high quality shielded instrument
cable to connect the guitar to the amplifier.
(7) VOLUME
Controls the volume level of the Clean channel and is not affected by the Lead, Pre or Post Gain controls.
(8) PRE GAIN
Controls the input volume level of the Lead channel. The Pre Gain can be used to control the distortion level in
the Lead channel. To obtain more distortion simply increase the Pre Gain and set the Post Gain (9) to the desired
volume level.
(9) POST GAIN
Controls the overall volume level of the Lead channel. The final level adjustment should be made after the desired
sound has been achieved.
(10) MODERN/VINTAGE SWITCH
This switch allows you to instantly change the voicing to reflect the tones of modern and vintage amplifiers. The
MODERN position maintains a warm, standard voicing. The VINTAGE position changes the overall function of the
EQ and adds a hint of brightness to emulate some classic amp designs. Experiment with this switch, along with
the EQ (11) adjustments, to capture your desired tone. You may refer to the Recommended Settings on page 6 for
some creative starting points.
(11) LOW, MID AND HIGH EQ
Passive tone controls that regulate the low, mid and high frequencies, respectively.
(12) CHANNEL SELECT
This switch selects the channel (Lead or Clean). The ACTIVE CHANNEL LEDs (13) indicate the active channel
— green for Clean; red for Lead.
(13 ACTIVE CHANNEL LEDs
These indicators signify the active channel. Green indicates Clean channel activation; red indicates Lead channel
activation.
(14) EFX ADJUST
Pressing this control selects the effect. A yellow LED adjacent to the effect name will illuminate to indicate the
selected effect. Rotating this control clockwise changes the parameter of the active effect according to the
descriptions below. The surrounding LED ring indicates relative value of the parameter being adjusted.
EFX ADJ PARAMETERS
EFX amps are built with factory settings loaded into the presets. To return to the factory settings, press
and hold both the EFX ADJUST (14) and DELAY (16) controls while turning the amp on.
(15) REVERB
10
9 11
Tremolo - Rate increase
Octaver - Wet/Dry mix
Flanger - Rate increase
Chorus - Rate increase/depth decrease
12 14
Funk Wah - Sensitivity increase
Rotary Speaker - Rate increase
Phaser - Rate increase
6
15 16 17