Table of Contents
Advertisement
Quick Links
Specifications
General
Frequency Response
10Hz - 60KHz +/-2db
T.H.D.
0.01% @ +4dbU/1KHz
Signal To Noise Ratio
Amplifier on & DSP on ? 70dB (-2dB)
Amplifier off & DSP on ? 75dB (-2dB)
Amplifier on & DSP off ? 72dB (-2dB)
Amplifier off & DSP off ? 77dB (-2dB)
Power
Dual PSU 115V/230V
Amplifier
2 x 200W RMS/2 x 400W Peak @ 8 Ohms
2 x 350W RMS/2 x 700W Peak @ 4 Ohms
Mixer
20 inputs - 6 x mic/line, 14 line
Electronically Balanced Inputs accept balanced or unbalanced sources
Gain Range
+10db to +44db
Mic Channel EQ
Hi +/-15dB @ 12kHz
Swept Mid +/-15dB @ 100 Hz to 8kHz
Lo +/-15dB @ 80Hz
Mic Channel Lo Cut Filters
18dB per octave @ 75Hz
Line Channel EQ
Hi +/-12dB @ 12kHz
Hi Mid +/-15dB @ 3kHz
Lo Mid +/-15dB @ 500Hz
Lo +/-12dB @ 80Hz
2 x Aux Send & Return
switched +4dBu & -10dBV operation
Aux 1
switched Pre/Post Fade
Channel Level Faders
60mm : +7dbU to -60dbU
7 Band Graphic EQ
+/-10dB @ 60Hz, 160Hz, 410Hz, 1.1kHz, 2.3kHz,
6.2kHz , 15.6kHz
Effects
A/D D/A Conversion
20BIT
Sampling Rate
46kHz
Dimensions
KMD10
535W x 410D x 185H (mm)
Weight
KMD10
18.5kg
w w w . k a m . c o . u k
K M D 1 0
p r o d u c t
m a n u a l
w w w . k a m . c o . u k
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for KAM KMD10
Summary of Contents for KAM KMD10
- Page 1 Effects A/D D/A Conversion 20BIT Sampling Rate 46kHz Dimensions KMD10 535W x 410D x 185H (mm) Weight KMD10 18.5kg w w w . k a m . c o . u k w w w . k a m . c o . u k...
- Page 2 Thank you for purchasing your new Kam KMD10 Mixing Console. This socket is electronically balanced so accepts either a balanced The KMD10 is designed to serve a wide range of uses for Live Sound, or unbalanced audio signal and automatically self adjusts Install or Project Studio.
- Page 3 Amplifier. If you want to Amplify the signal from the KMD10 mixer you will need frequency. The Line Channels - feature 4 band EQ. The Hi control applies +/- Any channel that is routed to the Alt 3&4 System via its Alt 3&4...
- Page 4 Main Mix. When either the PFL or Solo status connections to attach your recording device. Connect the L&R set on the KMD10 is accessed exactly as though it were an external LEDs are illuminated the meter will be measuring a signal source you marked 'Tape In' to the Record Input sockets of your recording processor.
Need help?
Do you have a question about the KMD10 and is the answer not in the manual?
Questions and answers