Maintenance; Removing The Cleaner From The Pool; Cleaning The Filter Basket - Pentair PROWLER 910 Installation And User Manual

Make sure the cleaner's power supply is turned "OFF" and is disconnected from the electrical source/outlet before servicing
the cleaner. Moving parts may injure hands or fingers if cleaner inadvertently powers on during servicing.

Removing the Cleaner from the Pool

The Prowler 910 Robotic Pool Cleaner will shut off automatically at the end of a cleaning cycle. Follow the steps below to
®
remove the cleaner from the pool.
Ensure the power supply is turned "OFF" and disconnected from the electrical source/outlet before removing the cleaner from
the pool. Operating the cleaner out of water will immediately cause severe damage and will result in loss of warranty. Do not
leave the cleaner in the pool all the time.
1. Disconnect the power supply cable from the electrical outlet.
2. Using the floating cleaner cable, slowly and gently pull the cleaner to the waterline
at the edge of the pool until you may reach the handle. DO NOT lift the cleaner out
of the water by the cable.
3. Using the handle, lift the cleaner out of the pool. See Figure 8.
Note: Never lift the cleaner out of the pool by the floating cable. This puts an
unnecessary strain on the cable and could result in damage to the cleaner.
4. Place the cleaner on the edge of the pool and allow excess water to drain from the
cleaner body and basket.
5. Disconnect the floating cable from the power supply.
6. Store the cleaner in a covered area with the floating cable coiled.

Cleaning the Filter Basket

Note: It is highly recommended that you clean the filter basket after each cleaning cycle. Too much debris in the filter will
restrict the suction power of the cleaner and reduce its effectiveness.
To clean the filter basket, follow the instructions given below:
STEP 1:
Open the Filter Cover and Remove the Basket
See Figure 9 and Figure 10.
Figure 9
KREEPY KRAULY
Figure 10
PROWLER 910 Robotic Aboveground Pool Cleaner Installation and User's Guide
® ®
STEP 2:
Empty and Clean the Filter Basket
Thoroughly clean the filter basket with a garden
hose. See Figure 11.

MAINTENANCE

Figure 8
Figure 11
3