Troubleshooting - Pentair PROWLER 910 Installation And User Manual

6

TROUBLESHOOTING

Problem
Cable twisting or cable
coils up.
Cleaner is moving in
circles
Cleaner does not reach
all areas of the pool
Motor not working
Cleaner will not sink
Power supply or power
supply switch light is
not working
KREEPY KRAULY
PROWLER
®
Possible Cause
Obstruction in pool
Gets stuck on main drain cover
Excess cable in the pool
Dirt stuck in moving parts
Tracks worn due to extended use
Power supply positioned incorrectly
Wrong mounting of bottom lid
Algae in pool.
Power supply positioned incorrectly
Algae on pool floor
Pool filter and pump is on
Impeller blocked
Drive system blocked
Electrical problem - motor unit, floating
cable, or power supply
Air caught in trapped in cleaner
Not plugged in properly or main socket is
damaged
910 Robotic Aboveground Pool Cleaner Installation and User's Guide
®
Corrective Action
Remove obstruction in pool.
Turn off filter and install main drain cover ring.
Straighten cable and lay in sun periodically.
Remove excess cable from pool.
Remove dirt from moving parts.
Contact your dealer. Replace tracks.
Place power supply in a position so that the cleaner
can reach all walls.
Lock bottom lid in the right position.
Correct pool and water conditions.
Place power supply in a position so that the cleaner
can reach all walls.
Brush pool floor.
Turn off pool filter and pump and run another
cleaning cycle.
Remove impeller tube. Clean impeller.
Clean tracks and wheels.
Consult with your dealer or service center.
Turn cleaner upside down under water to remove
trapped air. Wash the cartridge. Remove calcium
deposits or other chemical sediments.
Open inlet flap in the bottom lid to remove dirt and/or
trapped air.
Reconnect and check main power supply.