Advertisement
Control Knobs
The control knobs may be removed
for cleaning.
To remove knob, pull it straight
off the stem. If knob is difficult to
remove, place a thin cloth (like a
under and around the knob edge
and pull up.
Wash knobs in soap and water but
do not soak.
Clear
Groove
To replace knob, locate the groove
in each side of the knob stem. One
of the grooves contains a spring clip
and the other groove is clear. Locate
the molded rib inside the knob. Fit
the molded rib of the knob into the
clear groove on the knob stem.
Oven ~ermo*t
When cooking a food for the first
time in your new oven, use time
given on recipes as a guide. Some
oven thermostats, over a period of
years, may "drift" from the factory
setting, resulting in differences in
timing between an old and new oven
of 5 to 10 minutes. These differences
are not unusual and you may be
inclined to think that the new oven
is not performing correctly;
however, your new oven has been
set correctly at the factory and is
apt to be more accurate than the
oven it replaced. The thermostat
control on your new oven should
not "drift:'
If you think the oven should be
hotter or cooler, you can adjust it
yourself. To decide how much to
change the temperature, set the
oven temperature 25°F. higher or
lower than the temperature in your
recipe, then bake. The results of
this "test" should give you an idea
of how much the temperature
should be changed.
To adjwt temperature:
1. Touch BAKE pad.
2. Select an oven temperature
between 500°F. and 550°F.
3. Immediately, before BAKE
indicator stops flashing, press
and hold the BAKE pad for about
4 seconds. The red display will
change to the oven adjustment
display.
4. The oven temperature can be
adjusted up to (+) 35°F. hotter
or (–) 35°F. cooler. Use the
INCREASE or DECREASE pads
to select the desired change in
the red display.
5. When you have made the
adjustment, press the CLEAR/OFF
pad to go back to the time of day
display, Use your oven as you
would normally.
It will be remembered when
power is removed.
Advertisement
