Advertisement
1.7
THE DIGITAL SWITCH.
A 16 position miniature rotary switch is accessible through a hole in the back of
the transmitter. The switch is located on the left edge of the internal printed circuit
board, as shown in the following photo. It can be set to digital channels
A – F by rotation with a small screwdriver. The setting, or position, of this switch
sets the transmitter operating mode and the acoustic event detection threshold
as shown in the following table. Positions 0 – B select acoustic trigger mode, with
higher switch settings corresponding to higher thresholds and lower acoustic
sensitivity. Positions C – F select normal command mode (buttons only) with the
switch setting selecting the automatic fire rate for depressions of the "Fire B"
button. Holatron Systems can supply custom fire rates if required.
NOTE: Automatic firing always commences at the next cue after the last one
fired, whether it was semi-automatic or automatic. Semi-automatic firing
always commences at the next cue after the last semi-automatic cue
fired, even if automatic cues have been fired in the meantime.
Semi-automatic or automatic firing always commences at cue 1 after the
transmitter has first been enabled. Thus all receivers on the transmitter's
fixed channel can be reset to cue 1 at any time by turning the
transmitter's safety locking switch momentarily to "Safe" and then back to
"Transmitter Enabled".
Microphone
Digital Switch
(Transmitter with rear cover removed)
7 of 14
0 – 9 or
Advertisement
