Table of Contents
Advertisement
o
o
6.6.5 DOOR INTERLOCK SWITCH ADJUSTMENT
This procedure must be performed whenever the Push Rod Travel Adjustment pro-
cedure is performed.
a. Verify that interlock switch closes (when closing the door) prior to the door latching.
Perform step
(b)
if switch and door are out of sync.
b. With door closed, adjust set-screw at end of disk load arm (Figure 6-9) while
holding door closed against metal stop. Adjust set-screw until micro-switch is
almost adjusted flush to top of switch case. This ensures that as the nylon tips
on the push-rod wear down, the switch will still close.
STEPPER MOTOR
CLAMP MTG
SCREWS
77834769-A
AC CONNECTOR
RETAINING RING
Figure 6-9. Chassis Base Assembl y
PUSH ROD
6-23
Advertisement
Table of Contents
